Verbatim LED Panel PN22-W40-C35 Installation Manual

Mounting Instruction
Recessed Mount
Drawings and pictures are for illustration purpose only.
The model you have may vary.
1. Remove the ceiling tile at an appropriate location
where the product is to be installed.
2. Put product into the ceiling channel and properly
align it on the frame.
3. Bend hang buckle by 90°. Set it vertical to the rear
cover of panel. Bend hang buckle's top part by 90°.
Do the same for all the hang buckles.
4. Secure panel to the ceiling with aircraft cable or wires
capable of supporting 100lbs minimum (wire/cable not
included).
Aircraft cable
or wire
5. Remove the screw on driver cover. Connect main power
supply and dimming control lines through terminals
according to wiring diagram. Open one of the knockouts
and connect the strain relief (included).
6. Re-install driver cover onto driver housing and secure in
place with a screw.
Verbatim 5-year warranty www.verbatimlighting.com/warranty.
For support, visit www.verbatimlighting.com/support
This device complies with Part 15 of the FCC rules. Operation is subject to the following
two conditions: 1) this device may not cause harmful interference, and 2) this device must accept
any interference received, including interference that may cause undesired operation.
• AMERICAS: Verbatim Americas LLC, Charlotte, NC 28262
• EUROPE/MIDDLE EAST/AFRICA: Verbatim GmbH, Düsseldorferstrasse 13, 65760 Eschborn/
Germany
• AUSTRALIA/ NEW ZEALAND: Verbatim Australia Pty., Ltd., Unit 6, 450 Princes Highway, Noble
Park, Victoria, 3147 Australia Tel: +61 3 9790 8999 Fax: +61 3 9790 8955 Email: support@
verbatim.com.au
Installation Guide
Safety Information
• To reduce the risk of death, personal injury or property
damage from fire, electric shock, falling parts, cuts/
abrasions, and other hazards, be sure to read all
warnings and instructions included with and on the
fixture box and all fixture labels.
• The installation, service and maintenance of luminaires
must be performed by a qualified licensed electrician.
• Do NOT install damaged product.
• Make sure power is turned off at the breaker.
© 2017 Verbatim