Performing The Font And Status Print Tests - Epson ActionLaser Plus User Manual

Testing the Printer
5. Close the printer cover.
6. Print the self test again to check the new print density setting.
(To print the self test, make sure the printer is off line; then press
the and
MANUAL

Performing the font and status print tests

There are two other tests you can perform, in addition to the self
test. The font print test gives you information on available HP fonts
and the status test lists printer settings. Like the self test, the
successful completion of either of
correctly set up your printer and that you are ready to connect the
printer to your computer.
The font print test
The font print test gives you details
font source and font ID number, pitch, point size, available symbol
sets, and a print sample.
The symbol set ID numbers listed on the font print test (in
symbol set column) provide the unique portion of the escape
sequence needed to select that particular symbol set. For more
information symbol sets, see Appendix A, and for more
on
information escape sequences, see Chapter 5.
on
Follow the steps below to perform the font print test:
1. Be sure that your printer is plugged in and the power is on.
2. Be sure that your printer is off line. (OFF LINE appears on your
display.) If not, press the
line.
2-8 Testing and Connecting Your Printer
buttons at the same time.)
SPECIAL
these tests
on
ON LINE
indicates that you have
available HP fonts, including
button to set the printer off
the