Table of Contents
Advertisement
3. Insert the rotating inner sleeve and the rotating outer sleeve into the left side of the footrest
and the right side of the lower leg (note: the large step must face inward). (figure 3)
4. Open the footrest support hinge cover on the left and right mounts of the massage chair.
(figure 4)
5. Hang the lower leg (left and right shaft) into the frame support hinge plat at the same
time. (figure 5)
6. Cover the rotating shaft cover, press footrest rotating cover, and then tighten footrest
rotating cover board with two M5x14-12.9 screws and a flat pad with the supplied
hex wrench. (figure 6)
Massage Chair
Operating instructions
37
Advertisement
Table of Contents
