Table of Contents
Advertisement
3. Connect each plug and the air pipe securely. Once connected tuck excess wire into the
center frame. (figure 3)
4. Ensure that the air pipe has adequate room and is not being cut off or pinched. (figure 4)
5. Hold the handrail with both hands, connect the front end of the armrest into the steel frame,
and secure it in place. (figure 5)
6. Connect the LED lighting wire at the rear end of the armrest and tuck in the excess wire.
Then align the connectors on the rear of the armrest a connect them firmly in place. (note
that connectors must be properly spaced for accurate fit) (figure 6)
7. Secure the rear end of the armrest in place with a M6x20 screw. (figure 7)
8. Then secure the upper arm holster and install M5x16 screw. (figure 8)
Massage Chair
Operating instructions
35
Advertisement
Table of Contents
