Advertisement
Table of Contents
How to connect the ADS1000 external gas sampling system
To connect the external gas sampling system perform the following steps:
1) Insert the Luer lock connector to the gas sampling input and rotate it clockwise one
half turn.
2) Connect the two breathing circuits ends to the breathing circuit ports.
3) Now insert the gas sampling elbow into the end of the breathing circuit as shown.
4) Insert the Luer lock connector to the gas sampling elbow and rotate it clockwise one
half turn.
5) Connect breathing circuit to the gas sampling elbow.
1) Connect
Luer lock
connector
2)
Connect
breathing
circuit
1099 East 47 Street, Hialeah, Florida 33013
305-688-8581 - 800-445-8581 - FAX 305-685-7671
3) Connect
Gas
sampling
elbow
4) Connect
Luer lock
connector
5) Connect
breathing
circuit
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for ADS ADS1000
Summary of Contents for ADS ADS1000
- Page 1 How to connect the ADS1000 external gas sampling system To connect the external gas sampling system perform the following steps: 1) Insert the Luer lock connector to the gas sampling input and rotate it clockwise one half turn. 2) Connect the two breathing circuits ends to the breathing circuit ports.
- Page 2 ADS 1000 update letter # 07-2410 {Sept. 33 2007} Dear A.D.S. 1000 user, It is vitally important that the “Gas Sampling System” (elbow/feedback tube which connects to the breathing circuit), always be in place during every surgical procedure. Failure to use...
Need help?
Do you have a question about the ADS1000 and is the answer not in the manual?
Questions and answers