AEG FSE83807P User Manual page 11

Settings
Latest prog. selec‐
tion
Display on floor
Brightness
Language
Reset settings
PNC number
1) For more details, refer to the information provided in this chapter.
6.1 Setting mode
How to navigate in setting
mode
You can navigate in setting mode using
MY TIME selection bar.
A B
A. Previous button
B. OK button
C. Next button
Use Previous and Next to switch
between the basic settings and to
change their value.
Use OK to enter the selected setting and
to confirm changing its value.
How to enter setting mode
You can enter setting mode before
starting a programme. You cannot enter
setting mode while the programme is
running.
Values
ON
OFF (default)
ON (default)
OFF
From level 0 to level
9
List of languages
(default: English)
YES
NO
Number
C
Description
Enable or disable the automatic selection of
the most recently used programme and op‐
1)
tions.
Activate or deactivate TimeBeam.
Adjust the brightness of the display.
Set the preferred language.
Reset the appliance to the factory settings.
Check the PNC number of your appliance.
To enter setting mode, press and hold
simultaneously
about 3 seconds.
• The lights related to the
Previous, OK and Next are on.
• The display shows the first
available setting and its current
value.
How to change a setting
Make sure the appliance is in setting
mode.
1. Use Previous or Next to select the
desired setting.
The display shows the setting name and
its current value.
2. Press OK to enter the setting.
The display shows available values.
3. Press Previous or Next to change
the value.
4. Press OK to confirm the setting.
• The new setting is saved.
• The appliance returns to the basic
settings list.
5. Press and hold simultaneously
and
seconds to exit setting mode.
The appliance returns to the programme
selection.
The saved settings remain valid until you
change them again.
ENGLISH 11
1)
1)
and for
for about 3