Removing The Battery; Mower Storage - Cub Cadet SCP21E Operator's Manual

60v max li-ion battery powered push mower
Hide thumbs Also See for SCP21E:
Table of Contents

Advertisement

Available languages

Available languages

Removing the Battery

IMPORTANT: Use only with series CC6050 or CC6025 batteries.
When one or both batteries need to be charged, follow the steps
below to remove them:
1. Lift up the battery housing lid.
2. Push in the battery release tab (a). See Figure 14 inset.
3. While pushing in the battery release tab, firmly pull the
battery (b) out from the battery port.
NOTE: If necessary, repeat STEPS 2 and 3 to remove the
remaining battery from the mower.
NOTE: To replace with charged battery, refer to Installing Battery
on page 13.
4. Close battery housing lid.
Figure 14

Mower Storage

The following steps should be taken to prepare your lawn mower
for storage.
WARNING
Wait for motor and controller heat sink to cool before wiping.
1. Remove the push start safety key.
2. Allow the mower, battery and/or battery charger to cool.
3. Remove the batteries from the mower.
4. Using the handle adjustment levers, fold the handle forward
and lock in the down position.
OPERATION
(a)
(b)
5. Use air or a dry rag to clean the outside of the mower, battery
and battery charger.
IMPORTANT: DO NOT wash the mower with water. The warranty
will be voided if water is used on the mower.
• Inspect mower, battery and battery charger for any loose or
damaged parts. Replace damaged parts and tighten loose
screws, nuts or bolts.
• For storage between mowing seasons, coat mower's cutting
blade with chassis grease or oil to prevent rusting.
• Store mower indoors, in a dry, well-ventilated area. Do not
store next to corrosive materials, such as fertilizer.
• Store the battery and battery charger in an area that is
between 65 and 75° F (18 and 24° C).
• Always unplug the battery charger when it is not in use.
• Store the mower, battery and battery charger out of the reach
of children.
NOTE: If desired, the mower can be stored in a vertical position
(Figure 15). Adjust the cutting height to the lowest setting.
Lifting from the front edge, tilt the mower back until the mower
is resting on the rear wheels (a) and the handle brackets (b).
Position the mower so that the blade is facing a wall.
(a)
(b)
• Lock up the mower, battery and battery charger to prevent
unauthorized use or damage.
• If the battery is left unused for more than two months, fully
charge the battery before use.
16
Wall
Figure 15

Advertisement

Table of Contents
loading

This manual is also suitable for:

18aeb9c5b10

Table of Contents