Epson Stylus CX5000 Series Manual page 15

6. Squeeze the tab at the back of the cartridge and lift it
straight out. Dispose of it carefully. Do not take the used
cartridge apart or try to refill it.
Warning:
If ink gets on your hands, wash them thoroughly with soap and
water. If ink gets into your eyes, flush them immediately with
water.
7. Before you open the new ink cartridge package, shake it
four or five times. Then remove it from the package.
Caution:
Do not touch the green chip on the front of the cartridge. This can
damage the ink cartridge.
8. Remove the yellow tape from the bottom of the ink
cartridge.
Caution:
If you do not remove the yellow tape before installing the ink
cartridge, print quality may decline or you may not be able to
print.
Do not remove any other seals from the cartridges.
9. Place the new ink cartridge into the cartridge holder and
push it down until it clicks into place.
10. Replace any other cartridges that need to be replaced.
11. Close the ink cartridge cover and press it until it clicks into
place.
12. Close the scanner.
13. Press the B ink button. The CX5000 Series begins charging
ink and the light starts flashing. This takes about one
On
minute. When it's finished, the
remains on, and the B ink light goes out.
Caution:
Never turn off the CX5000 Series while the On light is flashing or
you'll waste ink.
Note:
B
If the ink light stays on (not flashing), the ink cartridge may not
be installed correctly. Press the
the ink cartridge until it clicks into place.
6/06
Epson Stylus CX5000 Series
light stops flashing and
On
B
ink button again and reinstall
15