Advertisement
Wired Installation of the Keypad
NOTE: If you also plan to power the keypad with the gate opener's power source, run two pairs
of wires as described below. One pair to hard-wire the keypad and the other pair to connect the
keypad to the gate opener's battery.
Step 1: Turn the gate opener's power switch OFF. Use 16 gauge, stranded, direct burial low
voltage wire (part no. RB509) to connect the keypad to the opener control board. Run wire
through PVC pipe from the ground to keypad and from the ground to the opener control board
to protect the wire from lawn mowers or grazing animals.
Determine how the wire will enter the keypad (i.e. from the back through a hole drilled in the
mounting post or running the wire on the surface of the post). Remove the small rectangular
knock-out on the back of the keypad cover and pull the wire into the cover. Then mount the
cover to the post using the screws provided.
Step 2: Wire the keypad to the gate opener control board. Strip 3/16" off the ends of one pair of low voltage wires. Attach the wires to
the terminal block marked RELAY on the keypad control board as shown. Then connect wire #1 to the CYCLE terminal on the gate
opener control board, and wire #2 to the COM terminal on the gate opener control board
To wire the power supply to the keypad attach the wires to the AC/DC POWER IN terminal on the keypad control board as shown to
the right. Connect the other end to the opener's battery - one end to the POSITIVE pole and
the other to the NEGATIVE pole.
NOTE: For a hard-wired application the jumper between the two terminals on the keypad
control board must be connected (ON) as shown. This will disable the 318 MHz RF
transmitter.
Step 3: Slide the keypad into the cover and secure with the
small screws provided.
Step 4: With the power to the
opener turned OFF. Remove
opener control board cover and
feed enough of the low voltage
keypad wire through a strain
2
3
1
ABC
DEF
relief to reach the gate opener
4
5
6
GHI
JKL
MNO
8
9
7
PRS
TUV
WXY
control board terminals.
0
Step 5: Attach the wires from the
keypad to the opener control board terminal
blocks as shown below.
Step 6: Replace the control board cover and turn the power switch ON. Test the keypad by entering 1 2 3 4.
Step 7: Program your 'Personal Master Code' and any additional entry codes (for a total of 25 entry codes) you wish. See Program-
ming the Keypad section.
Control Board Connections
NOTE:
Refer to your gate opener instruction manual for more details on wiring the gate opener control board.
Knock-out
+
0
–
1 2 3 4 5 6 7 8 9
RELAY
AC/DC
OUTPUT
POWER IN
Power Supply from
#
1
#
2
Opener Battery
Hard-wire from Gate Opener
Advertisement
