Gates that Open GTO Instructions

25 Code GTO Digital Keypad
Instructions for Wired and Wireless Installations
Keypad Features
Keypad
• The keypad illuminates and beeps at the press of any key.
• When a valid code is entered, the STATUS light will blink rapidly and the keypad will beep three time.
• The keypad remains active for 40 seconds after entering a valid code: pressing any key on the keypad while the gate is
in motion will stop the gate; pressing any key while the gate is stopped will cause the gate to reverse direction. After 40
seconds, the keypad will beep 3 three times and go into "idle" mode.
• If more than 20 key presses are entered without matching an Entry Code, the STATUS light will flash rapidly, an error
tone will sound for 1 second, and the keypad will go into "lock-down" mode for 40 seconds.
• If more than 10 seconds elapse between key presses, the keypad will beep 3 three times and go into "idle" mode.
Master and Entry Codes
• Up to 25 Entry Codes may be programmed into the keypad.
• Temporary Entry Codes can be programmed to expire within one to seven (1–7) days.
• Entry Codes remain stored in memory even when the keypad batteries go dead.
• All Entry Codes are deleted by pressing the RESET button on the keypad; Master Code defaults to "1234."
Gates That Open, LLC, "GTO" gate opener accessories are warranted by the manufacturer against defects in workmanship for a period of one (1) year
from the date of purchase, provided recommended installation procedures have been followed.
In the case of product failure due to defective material or manufacturer workmanship within the one (1) year warranty period, the accessory will be
repaired or replaced (at the manufacturer's option) at no charge to the customer, if returned freight prepaid to GTO 3121 Hartsfield Rd., Tallahassee,
FL 32303. IMPORTANT: Call 850/575-4144 or fax 850/575-8950 for a Return Goods Authorization (RGA) number before returning goods to factory.
Products received at the factory without an RGA will not be accepted. Replacement or repaired parts are covered by this warranty for the remainder of
the one (1) year warranty period or six (6) months, whichever is greater. GTO will pay the shipping charges for return to the owner of items repaired.
The manufacturer will not be responsible for any charges or damages incurred in the removal of the defective parts for repair, or for the reinstallation
of those parts after repair. This warranty shall be considered void if damage to the product(s) was due to improper installation or use, connection to an
improper power source, tampering, or if damage was caused by electrical power surge or lightning, wind, fire, flood, insects, or other natural agent.
After the one (1) year warranty period, GTO or one of its authorized service centers will make any necessary repairs for a nominal fee. Call GTO at
850/575-4144 for more information. This warranty gives you specific legal rights, and you may also have other rights which may vary from state to state.
This warranty is in lieu of all other warranties, expressed or implied. NOTE: Verification of the warranty period requires copies of receipts or other proof
of purchase. Please retain those records.
rev - 11-04-11
Thank you for purchasing the GTO Digital Keypad. Be sure to read the directions carefully
and completely. Before permanently mounting the keypad, please program the keypad and test
its range.
IMPORTANT: Your keypad may need to be hard wired due to the fact that it must accept
interference according to FCC regulations listed below. For example, applications
that are relativity close to cell towers or airports may receive intermittent interference and
require hard-wiring.
The GTO Digital Keypad is a multipurpose keypad that can work with other applications in
addition to GTO gate openers and locks. As a wired keypad it can operate garage door openers
and gate openers, that require 24 volts or less and accept normally open contacts.
As a wireless keypad, the keypad must be used in conjunction with the GTO garage door
receiver kit (part # RB709U-NB) on any other garage door.
SAFETY NOTE: Never install the keypad where a person can reach through the gate to
activate it, or where a person can touch the gate while activating the keypad. The recommended
minimum distance between the gate and keypad is 10 ft.
FCC WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in particular installations. If this equipment does cause harmful in-
terference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures: • Reorient or replace the receiver antenna. • Increase the
separation between the equipment and the receiver. • Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help.
Limited One Year Warranty
©2011 Gates That Open, LLC