Advertisement
If the luminaire will not strike, first determinme if power is available to the switch.
If the switch glows, there is power. Units older than 5 years may have plain switches.
In this case, check for power at the outlets on the light and source. If the luminaire
does not strike, the lamps may not be seated. Sometimes lamps are not seatedl
fully into the socket. Never try to replace lamp wth the fixture power on. This light
is rated to start at 50 degrees F or below. High temperatures affect lamp
colors and cause shortened ballast life. If the light flashes but won't stay on,
there may be a loose wire or bad electnonic ballast. Consult Fatory if the
luminaire is non-responsive. (214)-393-5998
The mirrored surface of this lighting product has the highest specular reflectance of
any commercially available material. With proper care it should perform well for
many years.
Fingerprints show up clearly and should be avoided. Dust adhering to the reflective
surface shows, as well. In the event that soiling should occur, the reflector can be
cleaned with little effort. It is best to start with a feather duster.
The clear coating of the reflective surface is chemically resistant and relatively
tough but can be scratched by rubbing dusty grit causing marks. The effect is
mostly cosmetic but should be avoided, especially for open fixtures. The best
cleaners are those which leave no residue. Glass cleaners work well, as do very
dilute solutions of hand dish wash detergents (1 drop/quart). Solvents stronger
than iso-propyl alcohol should never be used.
Never use paper towels or tissues as these materials are made from wood and will
cause scratches. Only soft cotton cloths should be used to wipe the surface. Use
single strokes along the long axis of the reflector. Never use an orbital motion. The
idea is that linear scratches don't show as much. Most scratches are caused by
dust and dirt being rubbed into the surface. Before wetting the mirror surface,
remove as much dust as possible using a feather duster or compressed air. Cloth
diapers or soft, (well used) terry cloth works best. Never use spray cleaners like
Formula 409, as these compounds leave residue. Spray on glass and mirror
cleaners work best. If you have any questions call (214)-393-5998.
CAUTION: ALWAYS DISCONNECT POWER BEFORE CLEANING THE
LUMINAIRE
onmpage4.ai
TROUBLE SHOOTING
REFLECTIVE SURFACE CARE AND MAINTENANCE
L i g h t i n g S y s t e m s
PrimeTime
Manufactured in the USA by:
PL Systems, Inc.
10529 OLympic Drive Suite 102
Dallas, TX 75220 (214)-393-5998
page 4
Advertisement
