Advertisement
INSTALLATION:
Remove the luminaire from the shipping carton and inspect for any damage during shipping.
If attenuators are ordered they may be installed in the aperture. If so, loosen the accessory
slot cover retaining screws and slide the cover back to expose the slot. Remove the accessory
to install the lamps which are shipped separately. see figure 4. Check the base of each
lamp to insure that you have the correct lamp color and CRI. See Table 1 for available lamps.
Table 1
LAMP COLOR
TUNGSTEN
TUNGSTEN
TUNGSTEN
OFFICE
OFFICE
DAYLIGHT
DAYLIGHT
After determining that the lamps are correct, install the lamps by gently inserting one side
of the lamp into the lamp clip. Then slide the base of the lamp into the socket while
aligning the four pins with the holes. A "snap" is felt when fully plugged in. See fig 3.
Caution: never remove or install lamps with active power to sockets as arcing can occur.
Always turn off the switch or unplug the power cable at the rear of the fixture housing.
When changing lamps allow a few minutes for cooling. Caution should be taken whether
installing or removing as glass chards could occur.
When the lamps are installed, it is advisable to
bench test each fixture. Plug the the power cord
in one luminaire and turn the switch on the
control panel ( fig 2 ). The switch should be lighted
if the ballast has power. The lamps should start.
Full intensity and correct color will be attained in
about 5 to10 minutes. Next, the hanging means
should be mounted on the yoke (fig 5 ) with a 1/2"
bolt supplied with the "C" clamp and or stem. If
vertical mounting is desired, the hanger or stem
should be attached on one end of the yoke brace. If daisy chain power is desired, up to
a total string wattage up to 800 watts, use of the "power out" receptacle. in figure (2).
OPEN
BOLT
TO CLEAR
PIPE
SECURE CLAMP TO BALE
fig 5
2blomp3.A1
KELVIN
3,000
3,000
3,200
3,500
4,100
5,400
5,600
Never install any lamp except twin tube Dulux or Biax with a
rating of 55 watts. Improper lamp installation will produce poor
TIGHTEN
BOLT
color and will shorten ballast life. Avoid mounting over people
AGAINST
PIPE
without a lens of some type (neutral filter) in case of non-
passive lamp failure. With the stems and "C"clamps attached,
hang each assembly in the desired location on the 2" pipe
grid or other qualified hanging system. Immediately add a
SECURE
SAFETY
CABLE
safety cable as per fig. ( 5 )
For assistance call (214)-393-5998, fax 393-5999
CRI
LUMENS
82
4,800
98
3,000
85
4,000
82
4,800
82
4,800
98
3,000
85
4,000
fig 4
lamp holder
install lamp
PLS PART#
FT55DL/830
FT55DL/930
FT55DL/832
FT55DL/835
FT55DL/841
FT55DL/950
FT55DL/856
remove
lamp
lamp clip
p 3
Advertisement
