Table of Contents
Advertisement
Figure 3-6 Attaching the Station Cable at the TCU Port
2. If a patch panel is to be used, attach the other end of the cable to
the appropriate patch panel jack. (An RJ-45 to MIC adapter may
be needed to connect between the TRRMIM-4AT TCU port and
the patch panel.)
3. Repeat these steps for each station.
3.6 FIBER OPTIC LOBE CABLING
When connecting a fiber optic link segment keep the following in
mind:
• When connecting a fiber optic link segment with ST connectors,
keep in mind that ST connectors attach to ST ports much like
BNC connectors attach to BNC ports. The connector is inserted
into the port with the alignment key on the connector inserted
INSTALLING THE REPEATER
8
X
9
R
X
O
10
T
X
R
I
11
M
X
12
X
Page 3-9
Advertisement
Table of Contents
