Advertisement
REMOVING SECURITY BARS
The security bars should remain in place while the MMAC-Plus 6 chassis is operating.
Remove the security bars by loosening the two screws which hold each bar in place. Slide the security bars out from
behind the interface module plastic tabs. Be sure to remove both security bars before attempting to remove any
interface modules from the chassis. Set the security bars aside for re-installation.
GETTING HELP
If you need additional support, or if you have any questions, comments, or suggestions concerning this addendum,
contact Cabletron Systems Technical Support:
Phone
CompuServe
Internet mail
FTP
BBS
For additional information about Cabletron Systems products, visit our
World Wide Web site: http://www.cabletron.com/
P/N 9032069
Security Bar
Interface Module
Plastic Tabs
MMAC-Plus 6
Chassis
Figure 2 Security Bar Installation
(603) 332-9400
Monday – Friday; 8
GO CTRON from any ! prompt
support@ctron.com
ctron.com (134.141.197.25)
Login
anonymous
Password
your email address
(603) 335-3358
Modem setting
8N1: 8 data bits, 1 stop bit, No parity
Tighten with
screwdriver
.
. – 8
.
. Eastern Time
A
M
P
M
Page 2 of 2
Advertisement
