Specifications; Cassette Section; Radio Section - LENCO SCD-420 Instruction Manual

Portable stereo fm radio with cd-player and cassette
Table of Contents

Advertisement

SPECIFICATIONS

CASSETTE SECTION

Track format:
Tape speed:
F.F. & REW time:
Frequency response:
CD SECTION
Channels:
S / N ratio:
Wow & Flutter:
Sampling frequency:
Quantization:
Pick up light source:
Pick up wave length

RADIO SECTION

Tuning ranges:
Antennas:
GENERAL
Output power:
Power consumption:
Speaker:
Phones jack:
Power source:
Dimensions:
Weight
Due to continuing improvement, the features and the design are subject to change without notice.
Guarantee
Lenco offers service and warranty in accordance with the European law, which means that in case of repairs (both during and after the warranty period)
you should contact your local dealer.
Important note: It is not possible to send products that need repairs to Lenco directly.
Important note: If this unit is opened or accessed by a non-official service center in any way, the warranty expires.
This device is not suitable for professional use. In case of professional use, all warranty obligations of the manufacturer will be voided.
Disclaimer
Updates to Firmware and/or hardware components are made regularly. Therefore some of the instruction, specifications and pictures in this documentation
may differ slightly from your particular situation. All items described in this guide for illustration purposes only and may not apply to particular situation. No
legal right or entitlements may be obtained from the description made in this manual.
Disposal of the Old Device
This symbol indicates that the relevant electrical product or battery should not be disposed of as general
household waste in Europe. To ensure the correct waste treatment of the product and battery, please dispose
them in accordance to any applicable local laws of requirement for disposal of electrical equipment or batteries.
In so doing, you will help to conserve natural resources and improve standards of environmental protection in
treatment and disposal of electrical waste (Waste Electrical and Electronic Equipment Directive).
CE Marking
Products with the CE marking comply with the EMC Directive (2014/30/EU) and the Low Voltage Directive
(2014/35/EU) issued by the Commission of the European Community.
Hereby, Lenco Benelux BV, Thermiekstraat 1a, 6361 HB Nuth, The Netherlands, declares that this product is in compliance with the essential requirements
and other relevant provisions of Directive 1999/5/EC.
The declaration of conformity may be consulted at techdoc@lenco.com
WARNING: Prolonged exposure to loud sounds from personal music players may lead to temporary or
permanent hearing loss.
Where to place the item :
Today's furniture is coated with a wide variety of lacquers and synthetic-coatings that are treated with an extensive range of cleaning products. Therefore,
the possibility that some of these substances contain components that react adversely to the rubber feet of the item and soften them, cannot be com-
pletely excluded. The rubber feet of the appliance can cause discoloring to furniture surfaces. If necessary, place the appliance on a non-slide surface.
®All rights reserved
Service
For more information and helpdesk support, please visit www.lenco.com
Lenco Benelux BV, Thermiekstraat 1a, 6361 HB, Nuth, The Netherlands
2 track stereo
4.75 cm / sec.
170 sec. (F-60 tapes)
125 Hz - 8000 Hz (Normal tape)
2 channels
60 dB
undetectable
44.1 kHz 8 x over sampling
1 bit DA converter
Semi - conductor laser
790 mm
FM 87.5 - 108 MHz
FM Rod antenna
1.2W + 1.2W (RMS)
13W
3" 8 OHM
3.5MM
AC : 230V~50Hz
DC : 12V ( 8 x 1.5V LR14/"C"/UM2 )
288(L) x 238(D) x 155(H)mm
2.2 KGS
GB 6

Advertisement

Table of Contents
loading

Table of Contents