LG LSP-430G User Manual page 13

LSP-430G EN_090303 2009.3.3 11:12 AM 페이지12
2. Introduction
STEP I. Check Components
The following components are supplied for Fixed
Wireless Phone.
1. LSP-430G Main Phone with Handset
2. Dipole Antenna
3. AC/DC Power Adapter
4. User Guide
Please make sure that these components are
present before you begin to install the phone. If
any of the components are missing or damaged,
contact your service provider immediately.
STEP II. Place the Terminal
Place the phone on the stable flat surface area
(desk, table, etc.). Serious damage may result if the
phone is dropped. Do not place the phone within
1 meter of heaters or radiators.
This phone is designed for desktop usage. Avoid
the direct exposure to sunlight and dampness.
12
Read the SAFETY INFORMATION located in the
first part of this document before you place the
phone.
-1EA-
STEP III. Connect Components
(Please refer to "Installation Steps" in 2.4)
-1EA-
Connect the antenna to the TNC antenna
-1EA-
connector located at the top of the phone. If you
-1EA-
have placed the phone on a flat surface, position
the antenna upright.
Connect the curl cord of the handset to the RJ-11
port located on the bottom side of the phone.
Connect the AC/DC Adapter cable to the DC input
port located at the top of the phone.
- If it is correct, a beep tone will be heard.
- If it is not correct (Booting fails or beep tone is
not heard), you will have to reconnect the
adapter.