Cabletron Systems 9C214-1 Installation Manual page 16

Installing the 9C214-1 Power Supply
c. Plug the power supply in the connector on the back of the chassis by
pushing the power supply in until its frame touches the surface of the
SmartSwitch 9000 chassis. Do not force the power supply in place. If
significant resistance is encountered before the frame is flush with the
chassis, remove the power supply, realign it, and push it in again.
d. Secure the power supply to the chassis by tightening the two screws on
the top and two screws on the bottom of the power supply. For proper
chassis grounding, the four screws must be properly tightened.
7. If you are installing a second power supply, repeat steps 1–6.
2-2
2
.
.
.
.
.
POWER SUPPLY MODULE
.
.
.
.
.
.
Figure 2-1. Installing the 9C214-1 Power Supply
1
.
.
P S
W N
R B
STATUS
.
100%
.
Load
50%
9C214-1
.
0%
.
.
.
.
.
.
100-125v-12A
200-250v-6A
50-60 Hz
Slot on
Chassis
Securing
Screws
Tab
Securing
Screws