Advertisement
TROUBLESHOOTING
Before calling for service, please review the Troubleshooting chart below, since the problem may not
be a unit malfunction.
SYMPTOM
Odours and smoke are not
removed.
The DUST SIGN illuminates green
even when the air is impure.
The DUST SIGN illuminates
orange or red even when the air is
clean.
A clicking or ticking sound is heard
from the unit.
The discharged air has an odour.
The unit does not operate properly
when cigarette smoke is in the air.
The DUST SIGN is turned off.
The DUST SIGN lights change
colour frequently.
AUTO RESTART
After a power failure, automatically
resume the operation when the
power recovers.
ON
(with the unit OFF)
(simultaneously for more than 3 sec.)
REMEDY (not a malfunction)
• Replace the filters if they appear to be heavily soiled.
(Ref. E-9)
• The air could be impure at the time the unit was plugged in.
Unplug the unit, wait one minute, and plug the unit in again.
• Sensor operation is affected if the dust sensor openings are
dirty or clogged. Gently clean the dust sensor openings.
(Ref. E-8).
• Clicking or ticking sounds may be audible when the unit is
generating ions.
• Check to see if the filters are heavily soiled.
• Clean or replace the filters.
• Plasmacluster Air Purifiers emit small traces of ozone which
may produce an odour.
• Is the unit installed in a location that is difficult for the sensor to
detect cigarette smoke?
• Is the dust sensor opening blocked or clogged?
(In this case, clean the opening.) (Ref. E-8)
• Check to see if the Lights OFF Mode selected.
Press
for 3 seconds to light On.
(Ref. E-7)
•
Check to see if the SLEEP mode is selected.
The DUST/PLASMACLUSTER SIGN are turned off automatically
after the SLEEP mode is selected.
• The DUST SIGN lights automatically change colours as
impurities are detected by the dust sensor.
Auto Restart can be set.
• Even when the plug is unplugged or the breaker is thrown
during the operation, the operation resumes at the previous
operation mode and settings if the power recovers.
If the
,
,
lamp Lights up
for 10 seconds, the setting is completed.
E-10
OFF
(with the unit OFF)
(simultaneously for more than 3 sec.)
Advertisement
