Windshield Washer Fluid - Cadillac 2007 SRX Owner's Manual

How to Check Power Steering Fluid
To check the power steering fluid, do the following:
1. Turn the key off and let the engine
compartment cool down.
2. Wipe the cap and the top of the reservoir clean.
3. Unscrew the cap and wipe the dipstick with a
clean rag.
4. Replace the cap and completely tighten it.
5. Remove the cap again and look at the
fluid level on the dipstick.
The level should be within the HOT mark. If
necessary, add only enough fluid to bring the level
within the mark.
What to Use
To determine what kind of fluid to use, see
Recommended Fluids and Lubricants on page 480.
Always use the proper fluid. Failure to use the
proper fluid can cause leaks and damage hoses
and seals.
380

Windshield Washer Fluid

What to Use
When you need windshield washer fluid, be sure to
read the manufacturer's instructions before use. If
you will be operating your vehicle in an area where
the temperature may fall below freezing, use a fluid
that has sufficient protection against freezing.
Adding Washer Fluid
The WASHER FLUID LOW ADD FLUID message
will appear on the Driver Information Center (DIC)
when the fluid level is low. See DIC Warnings and
Messages on page 220 for more information.
Open the cap with the
washer symbol on it.
Add washer fluid
until the tank is full. See
Engine Compartment
Overview on page 356
for reservoir location.