Turntable Motor; Quartz Heater - Panasonic NN-GD693S Service Manual

4.6.

Turntable motor

1. Remove the motor cover by breaking off at the 8 spots
indicated by arrows with a cutter or the like.
NOTE:
After removing the motor cover, be sure that cut
portions are properly trimmed or bent to the inside
so that no sharp edges will be exposed to outside.
2. Disconnect 2 lead wires connected to the turntable motor.
3. Remove the turntable motor by removing screw.
NOTE:
After reinstalling the new turntable motor and
reconnecting the 2 lead wires, reinstall the motor
cover by rotating it around 180, tucking the 2 tabs
under the base in the 2 provided slots, then screw
the single tab to the base using a 4mm × 6mm
screw.
4.7.

Quartz heater

1. Disconnect lead wires from both side of heater terminals.
2. Remove 2 screws holding upper heater panel to remove it.
3. Remove 2 nuts holding heater mounting plate to remove it.
13
NN-GD693S