en Troubleshooting
Fault
The programme does not
start.
The door cannot be opened.
The water is not draining.
54
Cause
- Finished In +
is activ-
ated.
Laundry is caught in the
door.
is activated.
The temperature is too high.
Water level is too high.
Programme with active oxy-
gen has been stopped; the
active oxygen is removed.
Power failure.
Drain pipe or water outlet
hose is blocked.
Drain pipe or water drain
hose is caught or jammed.
Drain pump is blocked.
is activated.
troubleshooting
Check whether - Finished In +
▶
is activated.
→ "Buttons", Page 23
Open the door again.
1.
Remove any trapped laundry.
2.
Close the door.
3.
Press Start / Reload
4.
the programme.
Continue the programme by select-
▶
ing Spin or
ing Start / Reload
→ "Resuming the programme when
the programme status is Rinse
Hold", Page 39
Wait until the temperature has
▶
dropped.
→ "Cancelling the programme",
▶
Page 38
Start the
Drain programme.
▶
Wait until there is no active oxygen
▶
in the drum.
Open the door using the emergency
▶
release.
→ "Emergency release", Page 59
Clean the drain pipe and the water
▶
outlet hose.
Ensure that the drain pipe and wa-
▶
ter drain hose are not kinked or
trapped.
→ "Cleaning the drain pump",
▶
Page 47
Continue the programme by select-
▶
ing Spin or
ing Start / Reload
→ "Resuming the programme when
the programme status is Rinse
Hold", Page 39
to start
Drain and press-
.
Drain and press-
.