Table of Contents
Advertisement
Press Start / Reload
4.
a The display shows
Start is activated. The appliance
waits to be started by the smart
energy system (energy manager).
a If the time changes on the display,
e.g. to 8 h, the smart energy sys-
tem (energy manager) has estab-
lished a time at which your appli-
ance can start.
a If the smart energy system (energy
manager) does not start the appli-
ance within the set time, the appli-
ance will start the programme itself
before the set time period ends.
The programme ends when the
time period ends.
Note
Flex Start is deactivated for safety
reasons in the following circumstances:
¡ Press Start / Reload
¡ Open the door.
¡ Switch off the appliance.
¡ Power failure.
Activating Wi-Fi on the appli-
ance
Note: When Wi-Fi is activated, the en-
ergy consumption increases in com-
parison to the values specified in the
consumption value table.
Press and hold Remote Start
1.
approx. 3 seconds.
Set the programme to position 4.
2.
a The display shows Con.
Press Start / Reload
3.
until the display shows On.
a Wi-Fi is activated.
Note: If Wi-Fi is activated, the appli-
ance will not switch itself off automat-
ically.
.
and Flex
.
for
repeatedly
Deactivating Wi-Fi on the appli-
ance
Press and hold Remote Start
1.
at least three seconds.
Set the programme to position 4.
2.
a The display shows Con.
Press Start / Reload
3.
until the display shows OFF.
a Wi-Fi is deactivated.
Note: If Wi-Fi is switched off and your
appliance was previously connected
to your home network, this connec-
tion will be re-established automatic-
ally when Wi-Fi is switched back on.
Software update
Requirement: The display shows
Upd.
Press and hold Remote Start
1.
approx. 3 seconds.
Set the programme to position 6.
2.
a UdP appears on the display.
Press Start / Reload
3.
a The software update is installed.
a If End is shown on the display, the
software update is installed.
Note: The software update may take
several minutes. Do not switch off the
appliance while the software update
is in progress.
Resetting the appliance network
settings
Press and hold Remote Start
1.
at least 3 seconds.
Set the programme to position 5.
2.
a The display shows rES.
Press Start / Reload
3.
a The display shows YES.
Press Start / Reload
4.
a The network settings are reset.
Home Connect en
repeatedly
.
.
.
for
for
for
43
Advertisement
Table of Contents
