Table of Contents
Advertisement
Improvements to the user interface
Velocity meter
In Combination and Sequencer modes, the note-on
velocity is shown in realtime by meters. This is a
convenient way to check the timbre or track that you're
working on.
Each time you press the Vel Mtr (Velocity Meter)
button, the velocity meters for the tracks will toggle
between visible and hidden. This setting is
remembered even when the power is off.
• These meters show the velocity values of note-on
messages received from the keyboard, MIDI IN,
KARMA, drum track, or sequencer. (If multiple
note-on messages are received simultaneously, the
highest velocity will be shown.)
• Since these meters show the note-on velocity
values, they will not reflect settings of the volume
sliders or changes in the audio signal level
produced by the filter, amp, EG, LFO, EQ, or
effects. Nor will they be affected if settings such as
KeyZone or VelZone indicate that sound is not
actually being produced by the note-on message.
• According to the Play/Mute or Solo settings, tracks
in play mode are shown with blue meters, and
muted tracks are shown with yellow meter.
12
Touch Drag editing
You can edit a value by dragging a knob or slider in the
display.
Note: There will be a brief time interval before the
arrow appears and the control responds. Use the Touch
Drag function to make approximate settings for the
knobs and sliders.
Note: It is convenient to use a commercially available
stylus pen for operating small components in the
display.
Knobs
When you touch a knob, a left/right arrow will appear.
In this state, drag left/right to use the knob and change
its value.
If the knob is a panner, dragging to the 12 o'clock
position will set the knob to C064, and dragging to the
6 o'clock position will set it to RANDOM.
Sliders
When you touch a slider, an up/down arrow will
appear. In this state, drag up/down to use the slider
and change its value.
Vel Mtr button
Pages and parameters where this is available
Examples in Combination/Sequencer
- P0: Mixer - Pan knobs, Volume sliders
- P0: KARMA RTC - sliders
- P0: Sampling - Recording Level sliders
- P0: Control Surface - various sliders
- P2: Trim/EQ - various knobs
- P7: IFX Setup - Pan knobs
- P8: MFX/TFX - various knobs, etc.
All knobs and sliders in each mode are also supported.
Track View and Piano Roll
The new Track View page and Piano Roll dialog box in
Sequencer mode allow you to specify a region of
measures or move/erase notes by operations such as
dragging.
☞ Refer to page 11 "Additional sequencer functions"
in this guide.
Advertisement
Table of Contents
