Cabletron Systems 9E423-36 User Manual page 17

Switch
8
7
6
5
4
3
2
1
Caution: Do not toggle Switch 8 unless you intend to reset the user configured
passwords to the factory default settings.
!
CAUTION
Caution: Do not toggle Switch 7 unless you intend to reset the user entered
parameters to the factory default settings.
Table 2-1. Function of DIP Switch
Function
This module stores user entered passwords in
NVRAM (Nonvolatile random access memory). To
clear these passwords, toggle this switch and then
Clear reset the module's processor. Once the module resets,
-1
Password factory default passwords are placed in NVRAM. You
can use these default passwords or, if desired, enter
new passwords. To enter new passwords, refer to the
Module Local Management User's Guide.
This module stores user entered parameters such as IP
addresses, subnet masks, default gateway, default
interface, SNMP traps, bridge configurations and
module specific configurations in NVRAM. To clear
Clear these parameters toggle this switch and then reset the
-2
NVRAM module's processor. Once the module resets, factory
default parameters are placed in NVRAM. You can
use the default parameters or, if desired, enter new
parameters. To enter new parameters, refer to the
Module Local Management User's Guide.
This module uses BOOTP (Boot Strap Protocol) to
download new versions of the image file into Flash
Force
Memory. This procedure forces image files to be
BOOTP
downloaded from the PC or Workstation, configured
Download
to act as the BOOTP server, connected to the EPIM
port in the Environmental Module.
For Factory Use Only
Reserved
For Factory Use Only
Reserved
For Factory Use Only
Reserved
For Factory Use Only
Reserved
For Factory Use Only
Reserved
Installing the 9E423-36 Module
Description
2-3