Advertisement
Please install and adjust the machine according to the requirements of the manual.
Correct operation is very important for your safety.
Unpacking
Unpack the carton and take out the bottom cover.
Open the top lid of washing machine and take out all of the accessories.
Remove all wrappers, including the polystyrene base.
You are advised to keep all the packaging for reuse in case the machine is to be
transported again.
Installing the bottom cover
Let the back of washing machine incline forward,
make the side of the bottom cover with sticker
description facing outside. Insert it to the bottom
of washing machine along the direction of the
arrow.
Remove two fixing clamp by scissors, insert it on
on the cover's aloted holes as shown on the figure
(gently pull fixing clamp and it should not be pulled
out). Make the bottom cover fixed on the base.
Positioning
The distance between the washing machine and the wall should be more than 50mm,
and the maximum allowable angle of the shank base of the machine is 1°.
The slanting or rough ground may cause operating stopped or unstable, please adjust it
with the following methods:
Make it horizontal.
Use a tied thread with plumb to check
if it is horizontal.
Adjust the adjustable foot
1) Lift up the adjustable foot gently, loose the adjustable nut
and twist the adjustable foot.
2) Fasten the nut after adjustment.
Fixing clamp
Scissors
Bottom cover
The base
Adjustable nut
Adjustable
foot
Advertisement
