Advertisement
1. Abnormal display
1. Abnormal display
Display
The top lid is opened
E0
when preset is started
After 15 minutes of draining
E1
time and still not reaching
the water level setting
The top lid is open when
E2
spinning
E3
Spin does not balance
After 20 minutes of water
filling time and still not
E4
reaching the water level
setting
E5
The top lid is opened
child-lock
after setting child-lock
light flashing
synchronously
Water level sensor is
F1
wrong
2. Imbalance adjustment
During spinning, if the laundries are not placed equally in the tub, it would cause
violent vibration.This machine has imbalance adjustment function, and the vibration
testing system will supervise the running. Once vibration is beyond certain level,
the adjustment system will start automatically to adjust the imbalance.
3. Power supply is cut off automatically
1) Press the power supply button and did not start the program in 10 minutes, the
power supply will be cut off automatically.
2) After the washing is finished, buzzer will activate. The power supply will be cut
off automatically.
4. Child lock function
1) If set child lock function, all the buttons will be locked including POWER. If the top lid is
opened during the washing machine working, the washing will be stopped and give an
alarm.But if you can close the top lid in 5 seconds, the washing machine will stop alarm and
continue working. If can not close the top lid in 5 seconds,the washing machine will begin
draining if there is water in the inner tub is 5 cm higher, alarm will be given every 10 minutes
(alarm is always given). When the draining is finished, the washing machine will be in the
stare of washing, if close the top lid, the washing machine is unlocked and start working as
previous setting.
2) Once child lock is set, if open top lid over 5 seconds during washing or rinse ( there is water
in the inner tub),washing machine will drain and give an alarm. If you unlock the function during
draining, the washing machine will add water to setting water level and continue working.
Explanation
Settlement
Close the top lid and clear up the alarm
Open the top lid and refer to the "before using"
procedures and "common non fault phenomenon"
on this manual to settle it, then close the top lid
and clear up the alarm.
Close the top lid and clear up the alarm
Open the top lid ,make the laundries
place equally, then close it and clear
up the alarm
Open the top lid and refer to the "before using"
procedures and "common non fault phenomenon"
on this manual to settle it, then close the top lid
and clear up the alarm.
Close the top lid and clear up the
alarm
Turn the power off and leave it for 1minute.
After that,turn the power on again.
If the same error is displayed,cut the
power suppy and call a technicians.
Advertisement
