Advertisement
Installation
Installation and electrical connections of the
machine must be carried out by an Authorized
Service Agent Review information in the user
manual and ensure that the electricity, water
supply and water drainage systems are
appropriate before calling an Authorized
Service Agent If they are not, call a qualified
technician and plumber to have any necessary
arrangements carried out
Preparation of location, electrical,
tap water and waste water
installations of the machine are the
customer's responsibility .
Warning: Installation and electrical
connections of the machine must
be carried out by an Authorized
Service Agent. The Manufacturer
shall not be held liable for damages
that may arise.
Warning: Prior to installation,
visually check if the machine has
any defects on it If so, do not
have it installed. A damaged
machine is a safety risk.
Ensure that the water inlet,
discharge hoses and power cable
are not folded, pinched or crushed,
during or after installation or
cleaning procedures
Appropriate installation location
• Place the machine on a rigid floor that has
sufficient load carrying capacity
• Choose a well ventilated dry location out of
direct sunlight
• Do not place the machine on the power cable
• Do not install the machine at places where
the temperature may fall below 0°C
• Place the machine at least 10 mm away from
the edges of other furniture
• Hot and cold water taps should be located
within 1 meter of the inlet valves
page7
Connecting the water supply
The water supply pressure required
to run the machine is between 1 to
10 bars (0 1 - 1 MPa) It is necessary
to have 10 - 80 litres of water flowing
from the fully open tap in one minute
to have your machine run smoothly
Attach a pressure reducing valve if
water pressure is higher
If you are going to use the double
water inlet machine as a single (cold)
water-inlet unit, you must install the
supplied stopper to the hot water
valve before operating the machine
(Only applies to machines supplied
with a blind stopper for closing off the
hot water valve)
Warning: Models with a single water
inlet should not be connected to the
hot water tap In such a case the
laundry will get damaged or the
product will switch to protection
mode and will not operate.
Warning: Do not use old or used
water inlet hoses on the new
machine. It may cause stains on your
laundry.
1 Connect the special hoses supplied with the
machine to the water inlets on the machine
Red hose (left) (max hot water temperature
for the machine is 60 °C) is for hot water inlet,
blue hose (right) (max 25 °C) is for cold water
inlet
Advertisement
