Product Database; Device Data For The System Integrator - Viessmann Vitogate 200 Installation And Service Instructions For Contractors

Commissioning
Integrating the Vitotronic control unit into LON
Updating the LON subscriber list
Vitotronic control unit installation and service
instructions
Carrying out a subscriber check
Vitotronic control unit installation and service
instructions

Product database

The product database for Vitogate 200, type KNX can
be downloaded at www.vitogate.info The product
database contains the ETS plug-in and the device
data.
Product database
After downloading, import the product database into
the ETS. Only then can the parameters be set for the
KNX/EIB system.
Note
If an error occurs while importing the product data-
base, the ETS must be re-started.

Device data for the system integrator

The device data contain all the data required for the
ETS for Viessmann appliances. New Viessmann appli-
ances and appliance types can be added by updating
the device data. After importing the device data into
the Vitogate 200, the data points in the relevant KNX
DPTs (KNX data point types) are available for setting
parameters with the ETS.
14
(cont.)
Note
If the subscriber check was successful, LON service
indicator "1" on the Vitogate 200 flashes green for
approx. 1 min. The Vitotronic display shows "Check
OK".
Note
If the user exits the parameter dialogue window with-
out making any changes, the ETS (EIB tool software)
considers the application to be no longer valid. The
application must be re-programmed.
Integration of the Vitogate 200, type KNX into the
KNX/EIB system is not part of the Viessmann stand-
ard delivery. It must be integrated by an authorised
contractor.