Commissioning; Integrating The Vitotronic Control Unit Into Lon - Viessmann Vitogate 200 Installation And Service Instructions For Contractors

Commissioning

Display and operating elements
Designation Status
KNX/EIB service indicator
"2" Off
Flashing red
Red
Display of KNX TP connection status
"3" Off
Yellow
Flashing yellow
Display for operating status
"4" Off
Flashing red
Green
Flashing green
Flashing green quickly
Operating elements
Button Meaning
"T1" No function
"T2" Programming the physical KNX TP address for manual integration of the Vitogate 200,
type KNX into an existing KNX/EIB system
"T3" LON service for manual integration of the Vitogate 200, type KNX into an existing LON
"T4" Software reset: Vitogate is re-started.
Commissioning
Plug the power supply unit into a standard 230 V~
socket.
LED "4" flashes green; Vitogate 200, type KNX is
being initialised.
As soon as "LED 4" illuminates green, the Vitogate 200
is ready for operation.

Integrating the Vitotronic control unit into LON

The LON communication module (accessory) must be
plugged into the Vitotronic control unit.
Vitotronic control unit installation and service
instructions
or
Communication module installation instructions
12
(cont.)
Meaning
Standard mode
Physical KNX/EIB address is being checked via ETS
(EIB tool software)
Receiving physical KNX/EIB address and application
KNX TP not active
KNX TP connected
Data transmission active in KNX TP
No power supply
Heating system fault
Standard mode
Initialisation running
Installing software update.
Note
The device must not be disconnected from the power
supply.
Note on LON integration
When commissioning the Vitotronic control unit, the
Vitogate 200 is automatically recognised as a LON
subscriber (see the following chapter).
Note
The data transfer via LON can take several minutes.