Replacing The Lower Cutter - Necchi NL11C Instruction Manual

1
3
4
v Replacing the lower cutter
Turn off the main power switch and unplug
the machine.
The stationary lower cutter should be
changed when it becomes blunt. Change it
by following the below instructions. If you are
having any difficulties, consult your service
agent to make the necessary adjustments.
- Turn off the upper cutter. Open the front
2
cover.
- Loosen the lower cutter set screw and
remove the stationary cutter.
- Place a new lower cutter in the groove of
the lower cutter holder. The blade of the
lower cutter shall be flush with the stitch
plate.
- Tighten the lower cutter set screw.
- Turn the upper cutter on again.
- Turn the hand wheel so the needles are in
their lowest position.
Non-cutting position
1
Cutting position
2
Lower cutter
3
Lower cutter set screw
4
38
n Attention