Changing The Presser Foot; How To Use The Upper Cutter; Deactivate The Upper Cutter; Reactivate The Upper Cutter - Necchi NL11C Instruction Manual

Changing the presser foot

1
3

How to use the upper cutter

Turn off the main power switch and unplug
the machine.
1. Raise the presser foot.
2. Turn the hand wheel toward you until the
3. Push the black button on the back of the
2
4. Place the new foot with the pin right
Optional feet are not included.
v Deactivate the upper cutter
-
1
-
v Reactivate the upper cutter
-
2
Always have the upper cutter in the cutting
position when sewing, because this
machine must trim off any excess fabric
to form the stitch over the fabric edge. An
exception to this is when sewing decorative
flatlock seams. Then the upper cutter
needs to be turned off.
7
n Attention
needles are in the highest position.
presser foot holder, and the foot will come
off.
underneath the groove of the ankle and
lower the presser foot. Push the black
button on the back of the presser foot
holder and the foot will snap into place.
Presser foot holder
1
Pin
2
The groove of the ankle
3
Note
Turn the hand wheel toward you until the
upper cutter is in its lowest position.
Turn off the upper cutter by switching
the upper cutter switch to non-cutting
position.
Turn on the upper cutter by switching the
upper cutter switch to cutting position.
Non-cutting position
1
Cutting position
2
Note