Table of Contents
Advertisement
Press Y to confirm.
7.
Select Rebuild Raid 1 Set, press Enter.
8.
When asked Are you sure(Y/N)?, press Y confirm. The mirror
will begin rebuilding. Do not interface with process.
9.
When rebuilding is finished, press Ctrl+E.
10. When asked Are you sure to exit(Y/N)?, press Y to exit and
reboot.
Deleting RAID Arrays
1.
As the BIOS boots press Ctrl+S or F4 when prompted to enter
the RAID BIOS.
2.
Select Delete RAID Set, then press Enter.
3.
Select the RAID set then press Enter.
4.
When asked Are You Sure(Y/N)?, press Y to confirm.
Resolving Conflicts
When a RAID set is created, then metadata written to the disk includes
drive connection information. If, after a disk failure, the replacement
disk was previously part of a RAID set (or used in another system), it
may have conflicting metadata. If so, this will prohibit the RAID set
from being either created or rebuilt, in order for the RAID set to
Mar/07
10
MN
Advertisement
Table of Contents
Need help?
Do you have a question about the ENLSA2-2C-PCIE and is the answer not in the manual?