JVC LT-22DD22J Operating Instructions Manual page 5

Important safety information
How to attach the stand
NOTE:
• Unplug the AC cord from the AC INPUT terminal.
• Before beginning this process, assure that TV is laid on a clean, safe, and cushioned space to avoid any
damage to the unit.
• Do not touch or press the TV-screen, glass might break under pressure.
• Be sure to follow the instructions. Incorrect installation of the stand may result in the TV falling over.
1) Place the TV on its front onto a table.
2) Align the stand's bottom-plate (supplied) as seen here.
It will fit in only one direction.
3) Hold the unit and attach the stand slowly. Finally secure the bottom-plate with 2 screws(included).
NOTE:
• To detach the stand, perform these steps in reverse order.
Dismantling the base
For wall mounting, the base must be dismantled. To do this, remove 3 screws (M, see page 10) from the
back. Take off the base entirely.
Important Instruction
For your own safety read following instruction carefully before attempting to connect this unit to the mains supply.
The wires in the mains lead are coloured in accordance with the following code :
GREEN
&
YELLOW
(Earth)
(if there is earth cable)
BLUE
(Neutral)
MAINS (AC) OPERATION
IMPORTANT
As the colours of the wires in the mains lead of this
appliance may not correspond with the coloured
markings identifying the terminals in your plug,
proceed as follows:
FUSE
The wire which is coloured green and yellow must be
connected to the terminal which is marked with the
letter E, or by the earth symbol, or coloured green or
green and yellow.
The wire which is coloured blue or black must be
connected to the terminal which is marked with the
letter N or coloured Black.
BROWN
The wire which is coloured brown or red must be
(Live)
connected to the terminal which is marked with the
letter L or coloured Red.
For continued protection against risk of fire,
replace only with same type and rating of fuse
(ASTA approved 5A 250VAC fuse).
5