Outdoor Revolution Eclipse Pro Annexe Instructions & Care Manual page 5

Packing Away Your Annexe

Extract the ground pegs from any secured guylines, storm straps and/or most
of the pegs surrounding the annexe, leaving the four corners pegged down.

Push the Dynamic Speed Valve button in; please ensure that the Oxygen Air
Frame Tube has been completely deflated before packing away.

Unpeg each of the four corners.

Lay the annexe canvas flat on the ground.
1. Fold the annexe vertically, from the opposite
ends to the valves, ensuring that all of the air is
pushed out, creating a streamlined sausage shape.
2. Measure the width of the carry bag up
against the width of the folded annexe to
ensure that the annexe will fit inside.
3. Begin to roll the annexe as tight as possible
towards the valves to expel all the air as you roll.
4. Place the rolled annexe onto the bag, pull
the sides up around it, then zip up the bag.
7
Please Read The Instructions Carefully
TIP: Refer to the photographs for assistance when erecting your Eclipse Pro Conservatory Annexe.
1. Spread the annexe canvas out flat on the
ground next to your caravan awning, with the
zip nearest the door you wish to attach it to.
2. Zip out the side door panel on the compatible
Eclipse Pro 380 caravan awning, on the side that
you intend to attach the annexe to. Store the
door panel somewhere dry/clean.
3. Zip the annexe onto the corresponding zip
on the side access point, ensuring that the
material is not pulled viciously and that no
parts of the fabric become caught in the zip.
4. Locate the Dynamic Speed Valve and ensure
that the valve is closed, before inserting the pump
OPEN
nozzle; the valve is closed when the button is
pressed out. There is a valve at the other end of
the tube; please ensure this is also closed.
CLOSED
5. Insert the pump nozzle into the Dynamic Speed
Valve and begin to carefully inflate, ensuring that no
part of the fabric have caught anywhere.
4