Outdoor Revolution Oxygen Speed Annexe Quick Start Manual

Outdoor Revolution

Thank you for purchasing an Outdoor Revolution product, this product will give years

of satisfactory service if basic instructions are followed, our products are designed for

Replacement tubes can be purchased to replace any items accidentally damaged.

** Annexes will not be swapped because of damaged tubes**

Please read the following instructions carefully

TIP: Refer to the photograph to help when pitching your Annexe.



Please do not leave for your vacation without fully erecting and checking the contents of your

annexe.



Ideally erect your annexe for some period allowing it to weather.



Please make sure that before erecting, that you site the annexe on clear Level ground with no

sharp objects underneath. (We recommend laying a groundsheet down to keep the annexe dry and

clean)



If you have any issues relating to pitching your annexe please contact your dealer for instructions

before going on holiday.



Please note this annexe is designed as a 'touring' annexe and not for 'permanent pitch'

use

(Make yourself familiar with the annexe and its parts before attempting to erect)

durability and for ease of erection

IMPORTANT PLEASE CHECK YOUR EQUIPMENT

Flysheet (or outer)

Pegs in separate bag

MODEL Oxygen Speed Annexe

Table of Contents

Need help?

Do you have a question about the Oxygen Speed Annexe and is the answer not in the manual?

Page 1 Outdoor Revolution MODEL Oxygen Speed Annexe Thank you for purchasing an Outdoor Revolution product, this product will give years of satisfactory service if basic instructions are followed, our products are designed for durability and for ease of erection Replacement tubes can be purchased to replace any items accidentally damaged.
Page 2 Outdoor revolution Awnings are all erected outer first Lay the outer/flysheet spread out on the ground. Slacken adjusters off on the black tapes (near the ring and pin assemblies) around the foot of the awning. Now decide which side of the awning you want the annexe and zip out the relevant panel. Take the annexe fly sheet and zip in.