Challenge PCS38Z Original Manual page 16

Operating the Chainsaw
How to confirm if the chain brake is functioning correctly
1. Turn off the engine and leave until cold.
2. With the chainsaw on a flat surface and the chain tensioned correctly, engage the chain-brake
by pushing it forward until an audible click is heard. Then, wearing protective gloves, attempt to
move the chain by hand in the direction of normal rotation if this is not possible the chain brake
has been engaged. If the brake is engaged when the chain is rotating at high speed for extended
periods of time this can cause damage to the clutch or for it to fail completely. When the brake is
activated whilst cutting, immediately release it having first released the throttle lever and set the
chainsaw to "STOP"."
Step 4 - Stop the engin
1. Release the throttle lever to allow the engine to idle for a few seconds.
2. Set the switch to the "STOP" position.
Important: Do not put the chainsaw on the ground when it is still running. For additional safety,
Switch the chainsaw off when not in use or between cuts. In the event that the ignition switch will
not stop the saw, pull the choke control out and engage the chain brake to stop the engine. If the
ignition switch does not stop the saw when set to the "STOP" position, have the ignition switch
repaired before using the chainsaw again to prevent unsafe conditions or serious injury.
NOTE! When you have finished using the saw, always relieve the tank pressure by loosening,
then retightening, the chain oil and fuel mix caps. Allow the engine to cool before storing.
16
switch
Customer Helpline 01904 727503
www.gardenservicecentre.co.uk