Challenge PCS38Z Original Manual page 11

Preparing to Operate the Chainsaw
Step 1 - Chain brake mechanical test
WARNING!
The purpose of the chain brake is to reduce the possibility of injury due to kickback; however, it
cannot provide the intended measure of protection if the saw is operated carelessly.
Always test the chain brake before using your saw and periodically while on the job.
a
Your chainsaw is equipped with a chain brake that reduces possibility of injury due to kickback.
The brake is activated if pressure is applied against the brake lever when, as in the event of
kickback, the operator's hand strikes the lever. When the brake is actuated, chain movement
stops abruptly.
To test the chain brake
a. The Chain brake is DISENGAGED (chain can move) when the BRAKE LEVER IS PULLED
BACK AND LOCKED.
b. The chain brake is ENGAGED (the chain is locked) when the brake lever is pushed forward. It
should not be possible to move the chain.
NOTE! The brake lever should snap into both positions. If this is not the case do not use your
saw. Contact the helpline immediately on 01904 727503
Customer Helpline 01904 727503
www.gardenservicecentre.co.uk
b
11