Table of Contents
Advertisement
Problem
There is too much frost and
ice.
The compressor does not
start immediately after
pressing the FastFreeze, or
after changing the tempera-
ture.
Water flows on the floor.
Temperature cannot be set. The FastFreeze or Shop-
DEMO appears on the dis-
play.
The temperature in the ap-
pliance is too low/too high.
If the advice does not lead to
the desired result, contact the
nearest Authorised Service
Centre.
7.2 Closing the door
1. Clean the door gaskets.
Possible cause
The door is not closed
correctly or the gasket is
deformed/dirty.
This is normal, no error
has occurred.
The melting water outlet is
not connected to the
evaporative tray above the
compressor.
ping function is switched
on.
The appliance is in dem-
onstration mode.
The temperature regulator
is not set correctly.
The food products' tem-
perature is too high.
The door has been
opened often.
The FastFreeze function is
switched on.
There is no cold air circu-
lation in the appliance.
2. If necessary, adjust the door. Refer to
3. If necessary, replace the defective
Solution
Refer to "Closing the door".
The compressor starts after a
period of time.
Attach the melting water out-
let to the evaporative tray.
Switch off FastFreeze or
Shopping manually, or wait
until the function resets auto-
matically to set the tempera-
ture. Refer to "FastFreeze or
Shopping function".
Keep the Mode pressed for
approximately 10 seconds
until a long sound is heard
and display shuts off for a
short time.
Set a higher/lower tempera-
ture.
Let the food products tem-
perature decrease to room
temperature before storage.
Open the door only if neces-
sary.
Refer to "FastFreeze func-
tion".
Make sure that there is cold
air circulation in the appli-
ance.
"Installation".
door gaskets. Contact the Authorised
Service Centre.
ENGLISH
11
Advertisement
Table of Contents
