Advertisement
Please refer to the Ice-O-Matic website for the most current version of
these
instructions.
www.iceomatic.com/Service-and-Support/ServiceDocumentation
IOM recommends cleaning and sanitizing be performed every 6 months
but no more than once per month.
CAUTION: Do not perform these cleaning procedures unless you are
wearing protective eyewear and gloves.
Before beginning the cleaning and sanitation process, all ice must be
removed from the ice bin.
Cleaning Instructions-Storage Bin/ Dispenser
1.
Follow instructions on Page 1, for machine Cleaning and Sanitizing,
before proceeding.
2.
Remove all ice from the bin or dispenser.
3.
Mix approved nickel-safe ice machine cleaner (diluted per
manufacturer's instructions) to yield one gallon of cleaning solution
and pour into the water trough. Refer to
approved chemical formulations.
4.
Thoroughly wash all surfaces within the bin, this includes the bin
door, bin walls, window track and snout area with cleaner. Note: An
extended handle soft bristle brush may be required.
5.
Allow the mineral deposits to absorb the cleaner for approximately
15 minutes to remove and loosen the mineral deposits. Note: This
includes the bin drain. Thoroughly rinse cleaner from all surfaces.
6.
Mix approved sanitizer (diluted per manufacturer's instructions) to
yield one gallon of sanitizing solution.
7.
Thoroughly wash all plastic surfaces within the bin, including the
bin door, bin walls, window track and snout area with sanitizer.
8.
Thoroughly rinse sanitizer from all surfaces.
CAUTION Do NOT use a chlorine-based cleaner on any stainless steel
surfaces-use soap and water instead!
Clean or Replace the Air Filter
1.
Using Vacuum and soft brush clean filter.
2.
Filter should be replaced if it is greasy, excessively dirty , or
damaged
3.
Reinstall the filter and front panel
3/8/2016
GEM and MFI Cleaning and Sanitizing
www.iceomatic.com
for
2
Advertisement
