Control Panel Overview - Brother DCP-T226 Online User's Manual

Home > Introduction to Your Machine

Control Panel Overview

1
5
6
7
8
(DCP-T220/DCP-T226/DCP-T420W/
DCP-T425W/DCP-T426W)
1. (Stop) Power On/Off
• Press to stop an operation.
• Press to exit from a selected mode.
• Press to turn on the machine.
Press and hold down
LED blinks and stays on for a few seconds before turning itself off.
If you turn off the machine using
To prolong print head life, provide better ink efficiency, and maintain print quality, keep your machine
connected to a power source at all times.
2. Power LED
Indicates the machine's status.
3. Warning LED
Indicates when the machine detects an error or is in Reset Mode.
4. Ink LED
Indicates when the machine detects an ink error or is in Maintenance Mode.
5. WiFi Button/LED (DCP-T420W/DCP-T425W/DCP-T426W/DCP-T428W)
• Press the button by itself or simultaneously with another button to configure the wireless settings or print
network reports. Use only when the machine is idle.
• Press this button and Color Start simultaneously to restart the Wi-Fi if you cannot connect to your
wireless network.
• Press simultaneously with
• Indicates the wireless network status.
> Control Panel Overview
2
3
4
to turn off the machine and cancel all of the remaining operations. The Power
, it will still clean the print head periodically to maintain print quality.
(Stop) to access the Wi-Fi Mode.
1
5
6
7
8
(DCP-T428W)
Connected
2
3
4
7