Installing The Handle - Homelite HPW2600 Operator's Manual Original Instructions

26. Run
27. Slot
28. Nozzle
29. Quick-connect collar
30. Detergent container
asseMBly
unPaCKing
This product requires assembly.
■ Carefully remove the product and any accessories
from the box. Make sure that all items listed in the
packing list are included.
■ Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
■ Do not discard the packing material until you have
carefully inspected and satisfactorily operated the tool
warning
Do not use this product if any parts on the Packing
List are already assembled to your product when you
unpack it. Parts on this list are not assembled to the
product by the manufacturer and require customer
installation. Use of a product that may have been
improperly assembled could result in serious personal
injury.
warning
If any parts are damaged or missing do not operate this
product until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
warning
Do not attempt to modify this product or create
accessories not recommended for use with this product.
Any such alteration or modification is misuse and could
result in a hazardous condition leading to possible
serious personal injury.
warning
To prevent accidental starting that could cause serious
personal injury, always disconnect the engine spark
plug wire from the spark plug when assembling parts.

installing tHe Handle

See Figure 3.
to install the handle:
■ Push and hold the button on the handle as you slide
the handle into the holes in the frame.
note: Before use, pull the handle up until the lock button
snaps through the locking slot to secure the handle in
place.
attaCHing injeCtion Hose
See Figure 5.
Before detergent can be used with this machine, the
injection hose must be attached.
■ Push the open end of the clear injection hose securely
over the fitting as shown in figure 5.
■ Place the filtered end of the injection hose in the bottle
of detergent.
asseMBling tHe sPray wand
See Figure 6.
To attach the lance:
■ Place the threaded end of the lance into the connector
on the end of the spray wand
■ Turn the connector clockwise until it stops. This
secures the lance in place.
ConneCting HigH Pressure Hose to sPray
wand
See Figure 7.
■ Screw the collar on the high pressure hose into the
spray wand's threaded connection by turning the hose
collar clockwise.
■ Pull on the hose to be certain it is properly secured.
ConneCting tHe HigH Pressure Hose to tHe
PuMP
See Figure 8.
After the high pressure hose has been uncoiled and
attached to the gun:
■ Align the hose collar and nozzle with the threaded
connection on the pump.
■ Turn the collar clockwise to tighten the hose securely
to the pump.
■ Pull on the hose to be certain it is properly secured.
The safety valve opens when the permissible operating
pressure is exceeded; water flows back to the suction side
of the pump. The safety valve is set by the manufacturer
and sealed. Setting only by customer service.
The thermo-valve opens when the permissible water
temperature is exceeded and prevents the pump from
over-heating.
5