Table of Contents
Advertisement
N1015158 OPERATING MANUAL
Quality, Reliability and Safety
This equipment has been designed with emphasis on QUALITY, RELIABILITY and
SAFETY, and Perkin Elmer will accept responsibility for these aspects only if the following
conditions are met:
a)
Electrical installation of the room or building in which the equipment is to be used
must comply with regulations specified in the country where the equipment is to be
used.
b)
The equipment must be used in accordance with the instructions for use provided
by Perkin Elmer.
c)
All modifications and repairs to the equipment must be carried out by DBS or its
authorised Agents.
d)
Modifications must not be carried out unless they conform to approved
Engineering Service Information issued according to the appropriate Perkin Elmer
procedure.
e)
The equipment installation must be carried out in accordance with local
requirements for responsibility and warranty.
1.3. Safety makings
CE mark
The "CE" mark for this product makes reference to the directives
•
89/336/EEC amended by 93/68/EEC for electromagnetic compatibility
•
73123/EEC amended by 93/68/EEC for low voltage
COPYRIGHT
All rights reserved. The information contained in this publication
may not be used for any purpose other that for which it was
originally supplied. The publication may not be reproduced in part
or in whole without written consent of Perkin Elmer. In order to
maintain and improve standards of manufacturing, methods of
functioning and to increase reliability, Perkin Elmer equipment is
periodically reviewed. For this reason, the contents of this
publication are subject to change without notice. The equipment
described is designed and manufactured by DBS.
3
Advertisement
Table of Contents
