Setting The Rinse Aid Amount; End Of Program - Beko DVS04020W User Manual

Setting the Rinse aid Amount

1. While the Program Selection Knob is
"Off", press and hold the Half Load/
Tablet function key of your machine
and rotate the Program Selection
Knob one step clockwise and keep the
function key pressed for 3 seconds.
Machine switches to rinse aid setting
mode.
2. When the rinse aid setting mode is
activated, the rinse aid level in the
memory is indicated by the program
monitoring LEDs for 5 seconds.
3. Bring the Program selection knob to
the proper position for the new rinse
aid amount setting.
4. Press the Start / Pause / Cancel key
once to record the selected setting in
the memory.
5. Machine returns to normal mode when
you bring the Program Selection knob
to "Off" position again.
1
2
5
3
4
Level of
Rinse Aid program
Amount selection
Applies 1
dose of rinse
.aid
Applies 2
dose of rinse
.aid
Applies 3
dose of rinse
.aid
Applies 4
dose of rinse
.aid
No dose of
rinse aid is
.applied
Rinse Aid Setting Indicator
knob
The washing indicator on
1
.the panel illuminates
The drying indicator on the
2
.panel illuminates
The End indicator on the
3
.panel illuminates
The Washing, Drying and
4 End indicators on the panel
The Washing, Drying and
End indicators on the panel
5
flashes with intervals of 1
determine if the rinse aid available in your
machine is adequate. You shall add rinse
aid to the rinse aid compartment when the
low rinse aid warning indicator starts to
illuminate.

End of Program

Program End indicator illuminates when the
washing program has ended.
1. Turn off your machine with the On-Off /
Program Selection knob.
2. Turn off the tap.
3. Remove the plug from the outlet.
After washing your dishes, keep them
inside the machine for cooling for
approximately 15 minutes. Your dishes
shall dry faster if you leave the door of
your machine ajar within this period.
This shall improve the drying efficiency
of the machine.
.illuminate
.second
31/EN