Vinotemp element EL-24THWB Owner's Manual page 13

SHELVES
- To prevent damaging the door gasket, make sure the door is fully open when pulling shelves out of the rail compartment.
- For easy access to the bottles stored, pull the shelves out approximately 90%.
- Only pull out one shelf at a time. Never attempt to pull more than one.
REVERSING THE DOOR
IMPORTANT: Any parts that you remove from the wine & beverage center while reversing the door should be kept
for later use.
1. Open the glass door and remove the two screws, under the right bottom corner of the glass door, that are used
to hold the right lower hinge to the door shaft assembly.
2. Be careful to support the glass door with both hands to prevent it dropping after removing the screws.
3. Pull down to remove the glass door and place it on a padded surface to prevent scratching it.
4. Remove the right top hinge and right lower hinge.
5. Take the left top hinge and left lower hinge from the plastic bag that contained this manual, and then install them
in the designated positions on the left side of the cabinet.
6. Install the door to the opposite side.
IMPORTANT: Check that the door opens and shuts correctly, without fouling, after you have completed the door
reversal process.
13