Vinotemp ELEMENT EL-WCU106-02 Owner's Manual page 16

Power
7
To turn off the appliance, touch the
Press again to turn on the appliance. The LED readout will show the original
temperature set previously when you restart the appliance or reconnect after power cuts.
Setting the Temperature Control
You can select the
touching the °C/°F Selector mark.
in blue color in the temperature display window. You can set the
by touching the UP and DOWN marks.
 The temperature will
 The temperature will
 Temperature range : 4 - 18°C/39 - 65°F
 The set temperature will appear in blue color in the LED display window.
Light switch positions are located inside the unit (shown above) for you to turn the backlight on/off.
Orange backlight
①
② Blue backlight
If you turn on the Blue/Orange backlight at the same time, do not leave them both on for a long
time since it can cause a high level of energy consumption.
Shelves
 To avoid damaging the door gasket, please make sure that the door is fully open when
pulling shelves out of the rail compartment.
For easy access to the bottles stored, you must

The shelves are designed to slide.
16
mark and hold for at least 5 seconds.
temperature display setting from Fahrenheit to Celsius degrees by
The Fahrenheit or Celsius degree indicator will appear
increase by 1°C or 1°F if you touch the UP mark once.
decrease by 1°C or 1°F if you touch the DOWN mark once.
W W W . V I N O T E M P . C O M
desired
pull the shelves out approximatel
temperature
y
90%.