Table of Contents
Advertisement
4-5
Setting
4-5-1
Setting of Time
The time is set on the LCD display screen by the following procedure:
[OPTION]+[MENU] key ・・・ Push and hold more than 3 seconds
ＳＥＴＴＩＮＧ
ＦＲＥＱＵＥＮＣＹ ［１７７５０００００］Ｈｚ
ＳＥＴＴＩＮＧ
ＯＵＴＰＵＴ ＰＯＷＥＲ
ＮＵＭＢＥＲ ＯＦ ＲＡＣＫ
ＮＵＭＢＥＲ ＯＦ ＰＡ／ＲＡＣＫ
ＤＡＴＥ／ＴＩＭＥ ＤＤ ＭＭ ＹＹＹＹ ＨＨ ＭＭ ＳＳ
Fig. 4-6 Setting menu of HPC-1508 TX control unit
Rotate the select SW, move a cursor to [DATE/TIME] and push the select SW. Then, edit
and set date/time. When you move a cursor to [ENTER] and push the select SW, the clock
starts from the setting time.
4-5-2
Setting of frequency, rated output power, and number of PA, etc
The necessary setting for operating the transmitter has been made by NEC before
shipping from the factory. However, if any change becomes necessarily, follow the
procedure described below.
(1) Connect the transmitter to a dummy load, or otherwise disconnect the RF input
from all PA.
(2) Push and hold more than 3 seconds [OPTION]+[MENU] key, the LCD display
screen changes to Fig. 4-6.
１ ＦＲＥＱＵＥＮＣＹ
２ ＯＵＴＰＵＴ ＰＯＷＥＲ
１ ＦＲＥＱＵＥＮＣＹ
２ ＯＵＴＰＵＴ ＰＯＷＥＲ
［１００００］Ｗ
３ ＮＵＭＢＥＲ ＯＦ ＰＡ
４ ＤＡＴＥ／ＴＩＭＥ
３ ＮＵＭＢＥＲ ＯＦ ＰＡ
４ ＤＡＴＥ／ＴＩＭＥ
［１６／０８／２００９ ２０：２０：２０］ ＜ＥＮＴＥＲ＞
4 - 14
＞
＜ＥＮＴＥＲ＞
＞
＜ＥＮＴＥＲ＞
＜
［ １］
［ ８］
＜
GWP-G22906
Advertisement
Table of Contents
