Installation; Pre-Installation Test - Wine Guardian DP25 Installation, Operation And Maintenance Manual

Installation

SHARP EDGES ARE PRESENT INSIDE THE WINE GUARDIAN PRO SYSTEM

Pre-installation Test

Test the system before installing it to check for non-visible shipping damage.
To test the system:
✓ Set the system on the floor or a sturdy level surface.
✓ Plug in the system.
✓ Press the on/off switch and check that the control illuminates. This indicates the
system has power.
✓ The built-in timer prevents short cycling and keeps the system from turning
on right away. The system comes on and runs as long as the temperature of the
space is above the thermostat set point. After several minutes, cold air comes out
of the system from the evaporator section side and hot air comes from the
condenser section. Listen for any unusual noise or vibration.
Modification to the equipment may cause injury or damage to the equipment
✓ This equipment is heavy. Place the unit on the floor or on a level and stable
surface that can support the full weight of the unit.
✓ Do not modify the equipment, it may cause damage to the equipment and will
void the warranty.
✓ Never place anything on top of the unit.
✓ Never block or cover any of the openings or outlets to the unit.
✓ Never allow anything to rest on or roll over the power cord.
✓ Never place the unit where the power cord is subject to wear or abuse.
✓ Do not use extension cords.
✓ Never overload wall outlets.
✓ Do not remove or open any cover unless the unit is turned off and the power
cord is unplugged.
✓ Use only dedicated power outlet boxes of the correct capacity and configuration
for the unit model.
WARNING
SHARP EDGES
RISK OF SERIOUS INJURY
WARNING
RISK OF PERSONAL INJURY OR DAMAGE TO EQUIPMENT
DANGER
.
33