Table of Contents
Advertisement
SWITCH ASSEMBLY
Apply the front label to the case as shown in
Figure F. Inserting the PC board into the front case
will aid in alignment of the label.
Cut the black and blue wires so you have two 4"
pieces of each color. Strip the insulation off of both
ends to expose 1/4" of bare wire.
Solder a 4" black wire to lug #1 as shown in Figure G.
Solder a 4" blue wire to lug #3 as shown in Figure G.
Insert the switch into the opening on the front as
shown in Figure H.
Front Label
Figure F
Back of Switch
3
4" Blue Wire
Figure G
Figure I
2
1
4" Black Wire
Black Line Cord Wire
3/4" Shrink Tubing
Strip the insulation off the black and white line cord
wires to expose 1/2" of bare wire.
Slip the 3/4" dia. shrink tubing over the line cord as
shown in Figure I.
Solder the black line cord wire to the #2 lug as
shown in Figure I. Make sure the tubing is away
from the soldering iron, so it will not shrink.
Slip the shrink tubing over the wires and switch as
shown in Figure J.
Use a heat gun or hair dryer and shrink all of the
tubing into place.
Switch
Shrink Tubing
-10-
Case
Figure H
Heat Gun
Figure J
Advertisement
Table of Contents
