Table of Contents
Advertisement
SWITCH ASSEMBLY
Apply the front label to the case as shown in
Figure F.
Solder a 4" white wire to lug #3 as shown in Figure G.
Solder a 4" black wire to lug #1 as shown in Figure G.
Insert the switch into the opening on the front as
shown in Figure H.
Strip the insulation off the black and white line cord
wires to expose 1/2" of bare wire if needed.
Front Label
Figure F
Back of Switch
3
4" White Wire
Figure G
Black Line Cord Wire
Figure I
2
1
4" Black Wire
Shrink Tubing
3/4" Shrink Tubing
-9-
Slip the 3/4" dia. shrink tubing over the line cord as
shown in Figure I.
Solder the black line cord wire to the #2 lug as
shown in Figure I. Make sure the tubing is away
from the soldering iron, so it will not shrink.
Slip the shrink tubing over the wires and switch as
shown in Figure J.
Use a heat gun or hair dryer and shrink all of the
tubing into place.
Switch
Figure H
Heat Gun
Case
Figure J
Advertisement
Table of Contents
