6.19. Remove the Reinforcement
Angles (L, R) and the
Connection Plate (A, B, C, D)
1. Remove the plasma panel section from the servicing stand
and lay on a flat surface such as a table (covered), with the
plasma panel surface facing downward.
Spread a soft cloth or similar on the table for protection, so
the panel surface is not scratched.
2. Remove the screws (×2
Reinforcement Angles (L, R).
3. Remove the screws (×2
mounting spacers B (×2 each) and the Connection Plate (A,
B, C, D).
4. Remove the Insuration mounting spacer A (A,B,C,D).
each) and remove the
each) and remove Insulation
TH-65PZ700A / TH-65PY700AZ / TH-65PY700H / TH-65PY700M / TH-65PY700MR
6.20. Remove the Fan unit (R) and
Fan
1. Disconnect the relay couper.
2. Remove the screws (×4
3. Remove the screws (×4
17
) and remove the Fan unit (R).
) and remove the Fan.